What wheels are you going to run with it?
In the end, I ordered the Elite Drive 65D wheels. so they will arrive within 20-30 days.
Also, I installed the Rear derailleur and bottom bracket, the Brake calipers, and brake hoses through the frame, and steering wheel. I added the Wheeltop shifters to the steering wheel and connected the cables. Cut in the end 20 gram from the tube from the front fork to fit. The Deda compression plug looks nice and sturdy on the steering handle as well.
The correct chainring with 52t arrived, but I don't have the correct chainring bolts yet for a 1x setup, ordered them. Same for the 8mm open-end wrench, I have it but I want to strengthen them with the right amount of force so I bought an adapter for my torque wrench, to have the brake hoses tighten with the oil pressure screws with a torque of 10-12 Nm.
That doesn't look too good. It doesn't look like the layers are especially well compressed. Looks very different from the inside of Oralmaster's frame. I hope he's a dentist, btw, or brushes his teeth a lot.
Didn't come from the same seller, right?
I checked the pictures of Oralmaster's frame and compared it to mine, however, I can only see the thread of the bottom bracket from him and compared to mine not really the inner layers. That it doesn't look good, is of course not what I would like to hear but maybe you can explain and educate us a bit like BeR also said in the comment, I also would like to know at what are you looking to compare to make such an comment.
On your question, There are different sellers for this frame and I think he has the one with the more expensive frame, his parts look also different then mine (he has more quality I think, that why I replaced them for better stuff), seatpost wedge, compression plug, headset bearings.
