Hi everyone,
I’ve finally installed the new Winow aerobars to replace the original ones. Overall, the process is relatively straightforward.
Disassembly:
First, you remove the stock aerobars.
Note: If your setup involves cables like my Shimano Di2, you’ll need to disassemble the buttons and be very careful with the electronic wires. If you’re using SRAM or something similar, you can just proceed with removing the bars.
The Angled Blocks: Next, you’ll need to mount the Winow angled blocks (I went with the 20° version). One thing to note: I expected these blocks to be larger to provide a wider contact patch with the aerobar, but they are actually quite small and narrow. However, once everything is tightened down, the system feels secure (though it still feels like it could be improved).
Mounting the Aerobars: Finally, you mount the aerobar onto the angled block. Since both the blocks and the bars are from Winow, I expected the bolt holes to align more perfectly. There are plenty of mounting options to fine-tune your fit, which is great. But, depending on the position you choose, you might only be able to secure two bolts—I personally feel that three would have been better for extra security.
The Challenges: My biggest struggle was the Di2 cables, which are at their length limit, restricting how much I can adjust the position. Also, I had a bit of a hard time installing the Shimano bar-end buttons. The tip of the aerobar was slightly narrower than standard, making it difficult to plug the buttons in.
